Nokia 7210 SAS-Mxp - Page 430

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Default "NO-TIME-RANGE" policy
priority priority
Specifies the priority of the time-range. Only one time-range assignment of the same type
and priority is allowed.
Values 1 to 10
Default 5
scheduler-policy
Syntax
[no] scheduler-policy scheduler-policy-name [time-range time-range-name] [priority priority]
Context
config>system>cron>tod-suite>egress
config>system>cron>tod-suite>ingress
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
This command creates time-range based associations of previously created scheduler policies. Multiple
policies may be included and each must be assigned a different priority; in case time-ranges overlap, the
priority will be used to determine the prevailing policy. Only a single reference to a policy may be included
without a time-range.
Parameters
scheduler-policy-name
Specifies a scheduler policy for this tod-suite, up to 32 characters.
time-range time-range-name
Specifies the name of the time-range, up to 32 characters. If the time-range is not
populated the system will assume the assignment to mean ‟all times”. Only one entry
without a time-range is allowed for every type of policy. The system does not allow the user
to specify more than one policy and the same time-range and priority.
priority priority
Specifies the time-range priority. Only one time-range assignment of the same type and
priority is allowed.
Values 1 to 10
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
430
SPACER TEXT