Nokia 7210 SAS-Mxp - Page 431

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
6.20.2.1.12 Script control commands
script-control
Syntax
script-control
Context
config>system
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
Commands in this context configure the script and script parameters.
script
Syntax
script script-name [owner script-owner]
no script
Context
config>system>script-control>script-policy
config>system>script-control
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
This command is used to configure a script to be run.
The no form of this command removes the script.
Default
no script
Parameters
script-name
Specifies the name of the script, up to 32 characters.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
431
SPACER TEXT