Nokia 7210 SAS-Mxp - Page 468

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
normal-state
Syntax
normal-state [open | closed]
Context
config>system>alarm-contact-input
Platforms
7210 SAS-T (network and access-uplink), 7210 SAS-Mxp, 7210 SAS-R6 and 7210 SAS-R12
Description
This command configures the normal state to be associated with the alarm-contact input. When the system
detects a transition from the normal state, an alarm is generated. The alarm is cleared when the system
detects a transition is back to the normal state.
Parameters
open
Specifies an open normal-state. When the system detects a transition to the closed state,
an alarm is generated. The alarm is cleared when the system detects a transition back to
the open state.
closed
Specifies a closed normal-state. When the system detects a transition to the open state,
and alarm is generated. The alarm is cleared when the system detects a transition back to
the closed state.
shutdown
Syntax
[no] shutdown
Context
config>system>alarm-contact-input
Platforms
7210 SAS-T (network and access-uplink), 7210 SAS-Mxp, 7210 SAS-R6 and 7210 SAS-R12
Description
This command stops tracking the state changes associated with the alarm contact input.The system does
not generate or clear the alarms for the alarm-contact input, but if an alarm is generated for the alarm-
contact-input, the system clears the alarm when the shutdown command is executed.
The no form of this command starts tracking the state changes associated with the alarm contact input.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
468
SPACER TEXT