7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
The resources can be shared with IPv4 ingress filter policies. See the 7210 SAS-Mxp, R6, R12, S, Sx, T
Router Configuration Guide for more information about how to allow filter policies using IPv4 criteria to
share resources with filter policies that use IPv6 criteria with 128-bit address and resource allocation and
fields available for use.
The no form of this command specifies that the software does not allocate any resources for use by
ingress filter policies using ipv6 criteria with 128-bit IPv6 addresses. If no resources are allocated for use,
the software fails all attempts to associate a service entity (for example, SAP and IP interface) with an
ingress filter policy using this match criteria.
Parameters
num-resources
Specifies the maximum amount of resources for use by this filter match criteria.
Some platforms include the value max. If the user specifies max, the software allocates
one chunk when the first SAP is associated with an ingress filter policy using this match
criteria. It continues to allocate resources to the service entity associated with an ingress
filter policy using this criteria, as long as the total amount of resources allocated does not
exceed the resources allocated to ingress filter policies (configured with the config system
resource-profile ingress-internal-tcam acl-sap-ingress command) and chunks are
available for use.
Values The following table lists the parameter values.
Table 50: Number of resources available for ipv4-ipv6-128-match-enable
Platforms Min value
(per node)
Max value
(per node)
Default
values
7210 SAS-T access-uplink mode (per node) 0 7 3
7210 SAS-T Network Mode (per node) 0 6 3
7210 SAS-R6 and 7210 SAS-R12 (per IMMv2) 0 (per IMM) 7 max
7210 SAS-R6 and 7210 SAS-R12 (per IMM-c) 0 (per IMM)
7
32
max
7210 SAS-Mxp (per node) 0 10 max
7210 SAS-Sx 1/10GE (per node) (standalone) 0 6 max
7210 SAS-Sx 1/10GE (standalone-VC) 0 5 max
7210 SAS-S 1/10GE (per node) (standalone) 0 6 max
7210 SAS-S 1/10GE (standalone-VC) 0 5 max
7210 SAS-Sx 10/100GE (per node) 0 4 max
32
The maximum value is 9 if acl-sap-ingress is configured as 9.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
527
SPACER TEXT
To Next Page
Loading...