Nokia 7210 SAS-Mxp - Page 534

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Values The following table lists the parameter values.
Table 54: Number of resources available for ipv6-64-only-match-enable
Platforms Min value
(per node)
Max value
(per node)
Default
values
7210 SAS-T Access-uplink mode (per node) 0 7 max
7210 SAS-T Network Mode (per node) 0 6 max
7210 SAS-R6 and 7210 SAS-R12 IMM-c (per
IMM)
0 9 max
7210 SAS-Mxp (per node) 0 10 max
7210 SAS-Sx 1/10GE (per node) (standalone) 0 6 0
7210 SAS-Sx 1/10GE (standalone-VC) 0 5 max
7210 SAS-S 1/10GE (per node) (standalone) 0 6 0
7210 SAS-S 1/10GE (standalone-VC) 0 5 max
7210 SAS-Sx 10/100GE (per node) 0 4 0
mac-match-enable
Syntax
mac-match-enable num-resources
no mac-match-enable
Context
configure>system>resource-profile>ingress-internal-tcam>acl-sap-ingress
Platforms
Supported on all 7210 SAS platforms as described in this document
Description
This command allocates maximum resources for use by ingress filter policies using mac criteria.
The resources cannot be shared with policies that use either IPv4 or IPv6 match criteria. Refer the
7210 SAS-Mxp, R6, R12, S, Sx, T Router Configuration Guide for more information about the resource
allocation for ingress filter policy and fields available for use with ingress filter policy.
The no form of this command specifies that the software does not allocate any resources for use by
ingress filter policies using mac criteria. If no resources are allocated for use, the software fails all attempts
to associate a service entity (for example, SAP and IP interface) with an ingress filter policy using this
match criteria.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
534
SPACER TEXT