Nokia 7210 SAS-Mxp - Page 566

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
port-scheduler-mode
Syntax
no port-scheduler-mode
port-scheduler-mode
Context
config>system>glob-res-profile
Platforms
7210 SAS-R6 and 7210 SAS-R12 (supported only on IMMv2 cards)
Description
This command lets user select the queuing mode to be used for SAPs configured on all the ports of the
node.
When port-scheduler-mode is enabled, software allocates 8 egress queues per port and all the SAPs
configured on the access port or hybrid port will share the 8 egress queues for traffic sent out of that port.
In this mode, SAPs configured on hybrid port shares the egress queues with network port traffic. Enabling
port-scheduler-mode affects the behavior for all the SAPs configured on all the access and hybrid port. In
this mode, per SAP egress queues are not available.
In this mode, resources allocated towards SAP egress queues in the ingress-internal-tcam pool are not
required by this feature and can be allocated towards other features. See the qos-sap-egress-resource
command for more information.
When port-scheduler-mode is disabled using the no form of this command, per SAP egress queues are
available for use. See the 7210 SAS-Mxp, R6, R12, S, Sx, T Quality of Service Guide for more information
about the two modes.
Enabling or disabling port-scheduler-mode requires a reboot of the node.
Default
no port-scheduler-mode
sf-ingress-internal-tcam
Syntax
sf-ingress-internal-tcam
Context
config>system>glob-res-profile
Platforms
7210 SAS-R6 and 7210 SAS-R12
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
566
SPACER TEXT