7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
CLI usage
Description
This command causes the console session to pause operation (sleep) for 1 second (default) or for the
specified number of seconds.
Parameters
seconds
Specifies the number of seconds for the console session to sleep, expressed as a decimal
integer.
Default 1
Values 1 to 100
ssh
Syntax
ssh [ip-addr | dns-name |username@ip-addr] [-l username] [-v SSH-version] [router router-instance|
service-name service-name]
Context
<GLOBAL>
Platforms
Supported on all 7210 SAS platforms as described in this document, including those operating in access-
uplink mode
Description
This command initiates a client Secure Shell (SSH) session with the remote host and is independent from
the administrative or operational state of the SSH server. However, to be the target of an SSH session, the
SSH server must be operational.
Quitting SSH while in the process of authentication is accomplished by either executing a Ctrl-C or
"~." (tilde and dot), assuming the ‟~” is the default escape character for SSH session.
Parameters
ip-address | host-name
Specifies the remote host for an SSH session. The IP address or the DNS name (if DNS
name resolution is configured) can be specified.
-l user
Specifies the username to use when opening the SSH session.
router router-instance
Specifies the router name or service ID.
Default Base
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
67
SPACER TEXT
To Next Page
Loading...