7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Appendix: 7210 SAS boot
procedures
Section Description
• Procedure to boot from the image on flash in manual
mode
This procedure uses the manual mode to boot the
7210 SAS device from the local flash.
• Procedure to boot from the network in manual mode
using uplink ports
This procedure uses the manual mode to boot the
7210 SAS device from the network using an uplink port.
• Procedure to boot from the network in manual mode
using the OOB Ethernet management port
This procedure uses the manual mode to boot from
the 7210 SAS device from the network using the OOB
Ethernet management port.
Procedure to boot when the
BOF is present locally
This procedure uses the BOF that is present locally to boot
the 7210 SAS device.
Procedure to boot in the
satellite mode
This procedure boots the 7210 SAS device in the satellite
mode.
Procedure to boot in the
standalone-VC mode
This procedure boots the 7210 SAS device in the
standalone-VC mode.
Note:
Console outputs shown in this chapter are examples only; actual displays may differ depending
on the 7210 SAS platform, supported functionality, and user configuration.
7.1 Procedure to boot using auto-init mode
About this task
Note:
The auto-init mode is supported on all 7210 SAS platforms, except the 7210 SAS-R6, 7210 SAS-
R12, and 7210 SAS platforms that are configured in the standalone-VC or satellite modes of
operation.
This section describes the procedure to boot the 7210 SAS using the auto-init mode.
The auto-init mode is used to boot the 7210 SAS device in the following scenarios:
• user boots the device for the first time
• user boots the device after a reset to the factory default settings
• user boots the device after the execution of the admin>reboot auto-init command
To boot using the auto-init mode requires a DHCP server to be configured in the network and reachable by
the system. The 7210 SAS device uses the auto-init mode to obtain the BOF from the network using the
IP address and file location provided by the DHCP server, and uses the parameters specified in the BOF
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
676
SPACER TEXT
To Next Page
Loading...