J
James TorresAug 27, 2025
What to do if Oki Printer cannot be resumed?
- MMarcus LopezAug 27, 2025
If printing cannot be resumed on your Oki Printer, turn the power OFF, verify that the carriage moves properly, then turn the power ON again.
To Next PageTo Next PageTo Previous PageTo Previous Page
Loading...What to do if Oki Printer cannot be resumed?
If printing cannot be resumed on your Oki Printer, turn the power OFF, verify that the carriage moves properly, then turn the power ON again.
What to do if my Oki ML1120 Printer has no power?
If your Oki printer has no power, first check that the power cable is properly connected to both the power outlet and the printer. If the connection is secure, plug another appliance into the same outlet to rule out a power outlet issue or outage.
Why is my Oki ML1120 Printer printing completely different characters?
If your Oki printer is printing incorrect characters or symbols, the issue might stem from an incorrect print setup for the user application. Reselect the print setup for the applications according to priority. It could also be that the application control codes from the previous print operation are still enabled; try initialising the printer. Verify the input application control signal is correct by printing in hex dump mode and making corrections in the application. Finally, ensure the interface cable is properly connected.
What to do if Oki Printer characters are too pale?
If the characters printed by your Oki printer are too pale, first ensure that the Paper Thickness lever position matches the paper type. If it is set correctly, check if the printer is set to print at high speed and set the speed to normal. If the issue persists, the ribbon may be at the end of its life or not installed correctly; try replacing or reinstalling the ribbon cartridge. The ribbon may also be wound incorrectly or not transferring properly, in which case, replace the ribbon cartridge.
What to do if Oki ML1120 prints content of a single form on two forms when using continuous forms?
If your Oki printer is printing the content of a single continuous form across two forms, ensure that the paper length selected in the application matches the physical paper length you are using.
What to do when Oki ML1120 Printer prints content of a single sheet on two sheets when using cut sheets?
If your Oki printer is printing the content of a single cut sheet across two sheets, match the paper setting selected in the application with the physical paper in use. Also, leave enough top and bottom margin in the application. Finally, correct the cut sheet LF adjustment.
How to fix Oki ML1120 when no printing takes place?
If your Oki printer isn't printing, several factors could be the cause. First, ensure the printer driver is correctly installed; if not, reinstall it. If the printer has simply stopped, press the SEL button. Also, check if there's paper loaded. Verify the interface cable is connected properly, and that you're using the correct cable. Finally, confirm the ribbon cartridge is installed.
How to fix Oki ML1120 when the print carriage does not operate?
If the print carriage on your Oki printer isn't operating, it might be due to contamination on the carriage shaft. Clean any paper dust and contamination from the carriage with a dry cloth.
What to do if Oki Printer has no paper feed?
If your Oki printer has no paper feed, ensure that the sheets are loaded with their left edges against the paper guide and that the sheets are loaded to the end.
How to resolve Oki ML1120 issue with paper has run out?
If your Oki printer indicates that the paper has run out, simply add paper and press the SEL button.
General| Noise level | 49.7 dB |
|---|---|
| Maximum duty cycle | 18000 pages per month |
| Maximum number of copies | 9 copies |
| Power requirements | 120 - 220V |
| Dimensions (WxDxH) | 889 x 587 x 379 mm |
Weight and Dimensions| Dimensions (W x D x H) (imperial) | 35 x 23.1 x 14.9 \ |
|---|
