Technical Reference Guide – Command descriptions > 173
Bottom margin:
Rear Feed: Approximately 1 in
Bottom Feed: Approximately 1 in
Top Feed: Approximately 1 in
> Additional details:
The paper out detector can also be enabled by MENU.
Manual Paper Out Override
While the paper end LED is on, if the SEL switch is
depressed, 1 line of data is printed, and a line feed follows
(paper override). During the processing of 1 line of data,
select mode returns.
The paper override function is effective after paper end is
turned on until the next TOF position. The paper override
function becomes invalid when it reaches the TOF position.
After the override function is processed to TOF position,
paper is reset at TOF position. When the SEL switch is
depressed, data is normally printed from the TOF position.
When the SEL switch is depressed after paper is reset
(paper end switch off), the following states return and the
printer is in the select mode:
– SEL LED on.
– Paper LED off.
– I/F assumes select (receivable) state.
During the paper override, if continuous line feed
exceeding the TOF position is input, line feed proceeds
until the TOF position. The remaining amount of line feed
is held until new paper is installed and printing executed.
Unprinted data will be saved in the buffer and printed after
paper is replaced and the SEL switch is depressed.
D
ISABLE
PAPER
OUT
SENSOR
> Code: ESC 8
> Compatibility:
ML1190 eco: EPSON LQ/IBM
ML1120 eco: EPS FX/IBM III
To Next Page
Loading...
