Technical Reference Guide – Appendix D – Media specifications > 235
M
ISALIGNMENT
BETWEEN
FEED
HOLES
Misalignment between feed holes of parts (resulting from
misalignment between the parts when being joined) must be less
than 0.4 mm.
B
INDING
HOLES
The use of paper that contains binding holes is not assured. (If
any problems occur with the use of such paper, equipment or
performance is not assured.)
When paper with binding holes is used in cases of absolute
necessity, adequate prior testing must be performed to check
that problems do not occur. Some precautions for using paper
with binding holes are as follows:
> Do not print data within 5 mm of each binding hole.
> Ensure that the paper is free of any chad resulting from
the punching of binding holes.
> Binding holes falling on the printer’s paper detection
switch are taken as paper ends.
> Ensure binding hole edges do not rise as hole edge rising
may cause the carriage to snag.
Feed hole
Misalignment 0.4 or less
[All dimensions in mm]
Sectional view of feed holes
To Next Page
Loading...
