Technical Reference Guide – Operator interface > 82
The number of reverse movements using the switch is limited to
one.
Do not perform reverse feed if the last sheet of continuous paper
will come off the tractor.
C
UT
-
SHEET
PAPER
SEMI
-
AUTO
-
LOADING
By loading paper on the input tray in cut-sheet mode or while
waiting for cut-sheet feed, semi-auto-loading starts after the
menu-set paper feed wait time (0.5 sec/1.0 sec/2.0 sec) has
elapsed.
Once started, cut-sheet paper is fed until the print position of the
first data line is reached, the printer is placed in the SELECT state
and the operation finishes.
The TOF set at that time is the printing start position of the first
data line.
F
ORM
TEAR
-
OFF
F
UNCTION
Form tear-off allows the user to tear the continuous forms paper
at a desired cut position by advancing the paper to the cutting
edge of the front upper cover.
S
ET
-
UP
1. Conditions:
(a) Continuous forms paper is loaded into the tractor
feed.
2. Tear Position:
(a) Load continuous forms paper.
Press the TEAR switch while On line to move the
paper up to tear position.
(b) Adjust to the desired tear position using fine LFs.
To Next Page
Loading...
