Technical Reference Guide – Appendix D – Media specifications > 237
> The locations of corner cuts are shown below:
P
APER
CONDITION
Paper should be without creases and be zigzag-folded along
horizontal perforations. In particular, paper newly taken from its
wrapping is likely to have creases in its first and last few sheets.
Do not use such sheets.
Do not use paper that exhibits wrinkling, curling or folds or paper
that turns upward at the top or bottom since this may
compromise print quality or cause paper jams. Note that the first
few sheets of new paper have a tendency to curl easily and it may
be advisable not to use them.
5.05
5.05
Corner cut
Perforations uncut
The hatched area must not be printed on
[ All dimensions in mm]
5~8
5~8
Line in paper
Mark made on
paper by folding
To Next Page
Loading...
