Oki ML1120 - Hex Dump Mode, Menu Mode, Test Mode

Technical Reference Guide – Operator interface > 38
H EX D UMP MODE , M ENU MODE , T EST MODE
TEAR + LF/FF Microfeed up (See
“note” on page 36.):
ML1120: 0.176 mm (1/
144 in) step.
ML1190: 0.141 mm (1/
180 in) step.
Microfeed up (See
“note” on page 36.):
ML1120: 0.176 mm (1/
144 in) step.
ML1190: 0.141 mm (1/
180 in) step.
TEAR + LOAD/EJECT Invalid Invalid
SEL + LF/FF +LOAD/
EJECT
Invalid Invalid
TEAR + LF/FF + SEL Invalid Invalid
TEAR + LOAD/EJECT +
SEL
Invalid Invalid
TEAR + LOAD/EJECT +
LF/FF
Invalid Invalid
PRINTER STATE
SWITCH
DESELECT (I.E. OFFLINE)
CONT. FORMS CUT-SHEET
SWITCH MENU TYPES
SEL LF/
FF
LOAD/EJECT TEAR
X O O X Activates Self Test
mode
X X O O Activates Rolling
ASCII when pressed
and printer powered
ON
O X O X Activates Hex Dump
mode
O X X X Activates Menu mode
O O X X Sets Menu factory
default setting
O O O X Activates Maintenance
Mode 1
(Note 1)