Oki ML1120 - Handling Continuous Forms

Technical Reference Guide – Operator interface > 36
TEAR + LF/FF Microfeed up (See
“note” on page 36.):
ML1120 eco: 0.176 mm
(1/144 in) step.
ML1190 eco: 0.141 mm
(1/180 in) step.
TEAR + LOAD/EJECT Invalid Invalid
SEL + LF/FF +LOAD/
EJECT
Invalid Invalid
TEAR + LF/FF + SEL Invalid Invalid
TEAR + LOAD/EJECT +
SEL
Invalid Invalid
TEAR + LOAD/EJECT +
LF/FF
Invalid Invalid
PRINTER STATE
SWITCH
SELECT (I.E. ONLINE)
CONT. FORMS CUT-SHEET
NOTE
While holding down the TEAR button, press the SEL or LF/FF
button to perform fine feed of paper. This allows for slight
movements of the paper in order to reach the cut-off position.
While holding down the SEL button, press the LF/FF or LOAD/
EJECT or TEAR button to change font type and font pitch and
print speed.
While holding down the LOAD/EJECT button, press the SEL or
LF/FF button to adjust loading position.