Oki ML1120 - Maintenance Mode 2; Special Switch Operations

Technical Reference Guide – Operator interface > 39
M AINTENANCE MODE 2
S
PECIAL SWITCH OPERATIONS
Hex Dump mode
> Enter Hex Dump mode by pressing the SEL + LOAD/EJECT
buttons at power ON.
> Exit Hex Dump mode by switching the printer OFF.
> The function of the other buttons does not change, that is,
the SEL, LF/FF, LOAD/EJECT and TEAR buttons all have
the same function as when in normal print mode.
> For more information, see “Hexadecimal Dump mode” on
page 80.
O O X O Activates Maintenance
Mode 2
(Note 1)
NOTE
When a Maintenance Mode is launched, the SEL LED lights
and waits for the switch to be pressed.
SWITCH MENU TYPES
SEL LF/
FF
LOAD/EJECT TEAR
SWITCH MENU TYPES
SEL LF/
FF
LOAD/EJECT TEAR
X O Activates Flash
Loading mode
NOTE
The above mode appears by pressing and holding down the
switch marked X and then pressing the switch marked O.