Oki ML1120 - Reset Perforation Auto Skip

Technical Reference Guide – Command descriptions > 114
Upon receipt of this command the printer sets the skip over
perforation to n lines.
> Range:
n = 1 to 127 (Epson), Number of lines to skip
n = 1 to 255 (IBM)
> Out of range:
If n is equal to or greater than the current form length, in
lines, this command will be:
– Set to form length (Epson mode).
– Ignored (IBM mode).
If n = 0 (or n > 127 in Epson mode), the last value will
remain set.
> Additional details:
Skip over perforation value will not be changed by the line
pitch change.
Entering the area of skip over perforation by LF, VT, CR
(with LF), ESC J n and auto line feed will cause skip over
perforation and feed to the top of form.
> Related functions:
Line spacing value is based on ESC 0, ESC 2, ESC A n, ESC
[ n or ESC 3 n.
ESC O resets skip over perforation.
R ESET PERFORATION AUTO SKIP
> Code: ESC O
> Compatibility:
ML1190 eco: EPSON LQ/IBM
ML1120 eco: EPS FX/IBM III
> Function:
Upon receipt of this code the printer resets the skip over
perforation value to the default value.
> Additional details: