Technical Reference Guide – Command descriptions > 122
DLL
FONT
SELECT
> Code: ESC % n
> Compatibility:
ML1190 eco: EPSON LQ
ML1120 eco: EPS FX
> Function:
Selects the character set to be used.
> Range:
When n = 01H, 31H, 81H, B1H, DLL character set selected.
When n = 00H, 30H, 80H, B0H, DLL character set cancel.
> Out of range:
When n does not equal any of the values above, this
command will be ignored.
> Additional details:
DLL character areas are 00H – 7FH.
If LQ DLL is loaded, LQ DLL will be selected.
If Utility DLL is loaded, Utility DLL will be selected.
F
OREIGN
CHARACTER
SET
SELECT
> Code: ESC R n
> Compatibility:
ML1190 eco: EPSON LQ
ML1120 eco: EPS FX
> Function:
Sets international character sets and code page.
“n” is defined in the table below.
To Next Page
Loading...
