Technical Reference Guide – Command descriptions > 121
Character Pitch and mode.
m b0 – b3: 0X00 UTLALL, 0X01 LQ 10CPI, 0X10 LQ 12CPI,
0X11 LQ Proportional
m b6 = 0, last table
m b6 = 1, another table follows
ad1 = 0 – 255, character starting address.
ad2 = 0 – 255
id1 b0 – b5, 1 – 63, Number of loading columns.
id1 b6 = 0 (RAM), b6 = 1 (ROM-CG copy)
id1 b7 = 0, Normal
id1 b7 = 1, Elongated
id2 b0 – b5, 0 – 63 character Width (Valid in proportional)
id2 b6 – b7, 0 – 0, Data for pins 19-24, copy 25-30 pins
id2 b6 – b7, 0 – 1 = Data for pins 23, 24, duplicated for
pins 25, 26, 27,28, 29, 30
id2 b6 – b7 1 – 0, Underline
id2 b6 – b7 1 – 1, No Elongation.
d1 = Repetition data for columns 1 – 8
d2 = Repetition data for columns 9 – 16
d3 = Repetition data for columns 17 – 24
d4 = Repetition data for columns 25 – 32
d5 = Repetition data for columns 33 – 40
0 = new data
1 = repeat previous column data.
> Additional details:
If fewer than 256 characters are loaded, all character
codes must be consecutive from the starting code point.
DLL characters are not saved after power is turned off.
This command makes a print block.
This command is broken into three parts:
1) ESC = n1 n2 # a1 a2 a3 m – once for each DLL
sequence.
2) ad1 ad2 id1 id2 d1 d2 d3 d4 d5 – repeated for each
character.
3) Data – repeated for each character.
To Next Page
Loading...
