Oki ML1120 - Identifying Component Parts; Front View

Technical Reference Guide – Introduction > 13
I DENTIFYING COMPONENT PARTS
The main parts of your printer are identified and briefly explained
below.
F RONT VIEW
1. Print Head: prints the characters on the paper.
2. Paper Type Lever: set according to the type of paper used
– cut sheet or continuous forms.
3. Platen Knob: turn to move or eject the paper.
4. Paper Thickness Lever: set according to the thickness of
the paper. There is also a setting to facilitate ribbon
replacement.
5. Control Panel: contains button switches and indicators
(described in detail later) that allow you to operate the
printer.
NOTE
It is not recommended that you use either the parallel or USB
port when the RS-232C option is installed in this product.
3
4
5
7
9
8
2
6
1