Technical Reference Guide – Command descriptions > 101
This command remains in effect until a new line spacing
command is sent to the printer.
This command does not set the top of form position.
> Related functions:
LF or CR (and the condition that Auto LF is on) executes 1/
6 in LF.
S
ET
N
/60
INCH
LINE
SPACING
> Code: ESC A n
> Compatibility:
ML1190 eco: EPSON LQ/IBM/PPR/IBM AGM
ML1120 eco: EPS FX/IBM III/PPR/IBM AGM
> Function:
Sets line spacing to: n/60 in Epson LQ, n/60 in IBM AGM,
n/72 in IBM PPR
> Range:
Range
n = 0 – 127 Number of 1/60 in increments – Epson
n = 1 – 255 Number of 1/60 in (1/72 in) increments – IBM
> Out of range:
Values of n not within the allowable range will be ignored.
> Additional details:
No line feed will occur when n = 0 in Epson mode. In IBM
mode if n = 0 this command is ignored, and the line
spacing in not changed.
Power on default or l-Prime signal resets the value set by
this command and sets the value determined by the Menu.
Top of form will not be set.
> Related functions:
ESC 2 is used to initiate the selected line spacing for IBM
PPR mode.
To Next Page
Loading...
