2KZ/2K0
1-4-45
(13) Paper is wrinkled.
(14) Image is off-set.
(15) Part of image is missing.
(16) Fusing is loose.
Print example Causes Check procedures/corrective measures
Paper curled. Check the paper storage conditions.
Paper damp. Check the paper storage conditions.
Defective pressure springs. Replace the fuser unit (see page 1-5-18).
Print example Causes Check procedures/corrective measures
Deformed or worn cleaning
blade in the drum unit.
Replace the drum unit (see page 1-5-16).
Defective fuser unit. Replace the fuser unit (see page 1-5-18).
Wrong types of paper. Check if the paper meets specifications. Replace paper.
Print example Causes Check procedures/corrective measures
Paper damp. Check the paper storage conditions.
Paper creased. Replace the paper.
Drum condensation. Perform the drum refresh operation.
Dirty or flawed drum. Perform the drum refresh operation.
Flawed drum. Replace the drum unit (see page 1-5-16).
Dirty transfer belt. Clean the transfer belt. Replace the intermidate transfer
unit if it is extremely dirty (see page 1-5-17).
Dirty transfer roller. Clean the transfer roller. Replace the transfer roller unit if it
is extremely dirty (see page 1-5-17).
Print example Causes Check procedures/corrective measures
Wrong types of paper. Check if the paper meets specifications, replace paper.
Flawed heat roller or press
roller.
Replace the fuser unit (see page 1-5-18).
Defective pressure springs.
Defective fuser heater.
Y113010-4 Sevice Manual