2KZ/2K0
1-3-57
U161 Setting the fuser control temperature
Description
Changes the fuser control temperature and control temperature correction value and other set
values.
Purpose
Normally no change is necessary. However, this mode can be used to prevent curling or creasing
of paper, or solve a fuser problem on thick paper.
Setting
1. Press the start key.
2. Select the item to be set.
3. Change the setting value using the cursor left/right keys.
4. Press the start key. The value is set.
Item No. Description
Display Description
Setting
range
Initial
setting
Copy
Curb(Edge)
Prevention temperature of overtem-
perature rise under copy
100 to 250 210
Curb(Edge) Prevention temperature of overtem-
perature rise
100 to 250 240
Return(Edge) Return temperature of overtempera-
ture rise
100 to 250 190
Ready(Edge) Ready display temperature 0 to 200 140
Pressure(Press) Pressurizing beginning temperature 0 to 200 100
High
speed(Center)
Full speed shift temperature 0 to 200 130
Ready(Center) Ready display temperature 100 to 200 150
Drive(Center) The second stability temperature 100 to 200 160
Full speed(Cen-
ter)
Print control temperature 100 to 200 160
Wait(Center) Control temperature when being
standing by
100 to 200 130
WarmUp
Curb(Center)
Electric power control temperature at
start-up
0 to 200 160
Curb(Center) Prevention temperature of overtem-
perature rise
170 to 250 240
Low power(Cen-
ter)
Low electric power control
temperature
0 to 200 90
Ready(Press) Ready display temperature 0 to 200 60
Curb(Press) Prevention temperature of overtem-
perature rise
170 to 250 240
Wait Off-
set(Press)
Correction temperature when being
standing by
0 to 200 100
Y113010-4 Sevice Manual
To Next Page
Loading...
