198
Connector Terminals with Transistors Section 5-6
User Customized
Boards
A board can be created by the user and mounted to the DRT2-@D32BV(-1).
This allows the user to create the required I/O system by placing I/O connec-
tors, relays, and other components as necessary on the board and then
mounting the board to a Board Terminal. The following diagram illustrates
mounting a customized user board to the DRT2-@D32BV(-1).
User Customized Board
Dimensions
Cut the user customized board to the dimensions shown below.
M4 screws
Stands:
10 mm
recommended
User customized board mounting holes
Recommended connector:
XG4H-4031-1 (from OMRON)
Mounted to mate with
MIL connector
User customized board (made by user
to user specifications)
DRT2-@D32BV(-1)
19.93
44.75±0.20
4.25±0.20
55.00±0.20
80.00±0.20
71.50±0.20
80.00±0.20
62.00±0.20
Four, 4.50 dia.
To Next Page
Loading...
Need help?
General
