121 HD-1500 Platform User's Manual 31500-000 Rev A
3.7 Installing the Charging Station
Figure 3-72. Docking Target Power Connector Installed in Desired Orientation (Sideways)
Connect the power cord to its mating connector on the docking target as shown in the fol-
lowing figure, and ensure that the power cord connector is seated completely and secured. The
power cord shall not lay in front of the docking target. It shall be properly protected, and must
not pose any hazards to the users or equipments.
Figure 3-73. Power Cord Connected to the Docking Target Power Connector
NOTE: If you need to connect the power cord to the docking target power con-
nector side ways, you must rotate it prior to mounting the docking target to the
wall.
To Next Page
Loading...
