Chapter 8: Maintenance
To replace the side skins:
1.
Move the skin to within a few inches of the chassis, and plug in the light disc con-
nector.
Connect the light disc to the fitting on the inside of the side skin.
2. Locate the alignment receivers on the chassis.
3.
Lift the skin's alignment pins onto the receivers in the chassis as shown in the fol-
lowing figure.
4.
Install the skin on to the chassis and ensure that it latches.
Release the E-Stop button to return the HD-1500 to service. See: Releasing an E-Stop on page
34.
Remove and Replace the User Access Panel Cover
The user access panel cover encloses the user access panel, and must be removed in order to
reach the available connections. Follow instructions provided in this section to remove or
install the user access panel cover.
You require:
l 3 mm allen wrench for M5 screws.
l Small flat-blade screwdriver.
Before you begin, press an E-Stop button and turn the HD-1500 off.
To remove the user access panel cover:
31500-000 Rev A HD-1500 Platform User's Manual 264
To Next Page
Loading...
