Panasonic fp2/fp2sh - Page 154

FP2/FP2SHInstallation and Wiring
4 − 24
4.4 Wiring the Connector Type I/O Units
When using cable with pressure connection terminal
The connector converted to a pressure connection terminal using the exclusive cable.
The I/O numbers and corresponding pressure connection terminal pin numbers are the
same as for connector terminals on section 4.4.3.
When using flat cable
There is a cable with a connector on only one end.
When using suitable connector, you can use a commercially available flat cable.
For detailed information
section 4.4.4
Table of Connector and Terminal
Number or connector pins 40 pins
Using con-
f
Housing Supplied with the unit
Mit
t
b
AFP2801
g
nector for
wire-pressed
Contact (for AWG22 and AWG24)
pp
Maintenance part number: AFP2801
w
i
re-presse
d
terminal
Semi-cover
terminal
cable
Pressure connection tool AXY52000FP
Using termi-
l
CT-2 con- DIN rail mounting type AYC1140
g
nal nector
terminal
Connector
terminal
1m/3.281ft. AYT51403
terminal
terminal
cable
2m/6.562ft. AYT51405
RT-2 relay
terminal
(
*
Note
2)
DIN rail mounting type AY231502 for input
AY232502 for output
(
*
N
o
t
e
2)
Connector
terminal
1m/3.281ft. AY15633
terminal
cable
2m/6.562ft. AY15635
Using cable
with pres-
1m/3.281ft. AYT58403
with
pres
sure connec-
tion terminal
2m/6.562ft. AYT58405
Using flat
bl
Flat cable with a
d
1m/3.281ft. AFB8541
g
cable connector on one end
2m/6.562ft. AFB8542
Connector only AFP2802 (40-pin connectors)
Notes
1) The connectors for wire-pressed terminal cable (40 pins) are
supplied with the unit.
2) The RT-2 relay terminal cannot be used with PNP collector out-
put type output units (FP2−Y32P, FP2−Y64P, FP2−XY64D2P
and FP2−XY64D7P).