FP2/FP2SHProcedure Until Operation
5 − 6
5.2 Programming with Programming Tool Software
5.2.2 Configuration of Programming Tool Software
Depending on the PLC type and conditions of use, it is necessary to set the basic
configuration for programming tool software. Be sure to set these parameters of con-
figration before beginning programming.
5.2.2.1 Parameters and Setting Methods
Select PLC type
Select the PLC type that is being used.
Expansion memory unit used Selection
None installed FP2 16k
The FP2−EM1 or FP2−EM7 is installed FP2 16k
The FP2−EM2, FP2−EM3, or FP2−EM6 is installed FP2 32k
FP2SH CPU type Selection
FP2−C2L FP2SH 32k
FP2−C2, FP2−C2P FP2SH 60k
FP2−C3P FP2SH 120k
After your selection, you can change the PLC type.
To Next Page
Loading...
