ed
cou
nter
unit
unit
(PP2
/PP4)
unit
(Mul-
ti−
func-
tion
type)
unit
RTEX
unit
Inter-
pola-
tion
type
com-
mu-
nica-
tion
unit
MEW-
NET−
F
mode
MEW-
NET−
W
mode
MEW-
NET−
W2
mode
mu-
nica-
tion
−VE
Link
Unit
A A
A
A
A
*1
A
*1
A A A A A
A
*2
A
A
*3
A
*2
A
*2
A
*2
A
*2
A
*2
A A
A A A A
A
*1
*5
A
*1
*5
A A A A A
N//
A
A
A
*3
N/
A
N/
A
N/
A
A
*2
N/
A
A A
A A
N/
A
N/
A
A
*6
A
*6
A
*7
N/
A
N/
A
N/
A
A
N//
A
A
*8
N/
A
N/
A
N/
A
N/
A
N/
A
N/
A
N/
A
N/
A
A A
N/
A
N/
A
A
*6
A
*6
A
*7
N/
A
N/
A
N/
A
A
N//
A
A
*8
N/
A
N/
A
N/
A
N/
A
N/
A
N/
A
N/
A
N/
A
A: Available N/A: Not available
Notes
1) When “Mode B: Unit with interrupt function” has been speci-
fied, the unit will be treated as interrupt unit, and 8 interrupts
per unit will be available for use. However, when “Mode B” has
been set for the unit, 2 units can be used with 1 CPU unit.
When “Mode C: Intelligent unit that generate interrupts” has
been specified, and 1 interrupt per unit will be available for
use. However, when “Mode C” has been set for the unit, 8
units can be used with 1 CPU unit.
2) Check the limitations on combining link units given below.
3) In the MEWNET−F mode, up to four units can be used counting
the CPU and expansion sides.
4) With the backplane H type, the total expansion cable length
can be arranged within 3.2 m.
5) The unit cannot be installed on the 31st slot (last slot) when
using the H−type backplane.
6) The interrupt function is not available for the backplane on the
slave station system.
7) With the backplane on the slave station system, the time taken
from the startup until the completion of positioning should be
longer than a scan time.
8) With the backplane on the slave station system, I/O points
cannot be set including 96 input points and 96 output points.