FP2/FP2SHOverview
1 − 14
1.2 Unit Types and Combinations
Type Part number Current con-
sumption at
5V DC (mA)
Intelligent
C.C.U. FP2−CCU 60 or less
unit
S-LINK unit FP2−SL2 130 or less
Multi-wire link unit FP2−MW 220 or less
Remote I/O Slave Unit FP2−RMS 150 or less
ET−LAN unit FP2−ET1 670 or less
MEWNET−VE Link unit FP2−VE 670 or less
FNS unit
FNS unit FP2−FNS 55 or less
PROFIBUS AFPN−AB6200 230 or less
Block
Device Net AFPN−AB6201 65 or less
CAN open AFPN−AB6218 65 or less
FMU unit
PROFIBUS FP2−DPV1−M 450 or less
Device Net FP2−DEV−M 150 or less
CAN open FP2−CAN−M 450 or less
Table of current consumption at 24V DC
Type Part number Current consumption at
24V DC (mA)
Input unit DC input 16-point terminal type, 12 to 24V DC FP2−X16D2 8 or less per one point
32-point connector type, 24V DC FP2−X32D2 4.3 or less per one point
64-point connector type, 24V DC FP2−X64D2 4.3 or less per one point
Output unit Relay output 6-point terminal type FP2−Y6R 70 or less
16-point terminal type FP2−Y16R 160 or less
Transistor
16-point terminal NPN type FP2−Y16T 120 or less
output
32-point connector NPN type FP2−Y32T 140 or less
64-point connector NPN type FP2−Y64T 250 or less
16-point terminal PNP type FP2−Y16P 70 or less
32-point connector PNP type FP2−Y32P 150 or less
64-point connector PNP type FP2−Y64P 270 or less
I/O mixed unit 32-point 24V DC input/32-point connector NPN
Input: 4.3 or less per one point
FP2−XY64D7T
Output: 120 or less
32-point 24V DC input/32-point connector PNP
output type
FP2−XY64D2P,
FP2−XY64D7P
Input: 4.3 or less per one point
Output: 130 or less
Notes
• The input unit displays the current flowing to the internal cir-
cuit. The other units display the current value required to drive
the internal circuit. This value does not include the load cur-
rent of the output unit.
• Refer to the manual of the particular unit you are using to
confirm the current consumed at 24V by the S-LINK units,
Positioning units, High−speed counter units and Pulse I/O
units.
To Next Page