Panasonic KX-NS1000 - Page 533

15.1.20 Private Network Features—QSIG—CLIP/COLP (Calling/Connected Line Identification Presentation)
and CNIP/CONP (Calling/Connected Name Identification Presentation)
CLIR Set / Cancel
Specifies the feature number used to set or cancel CLIR, which suppresses the presentation of the caller
’s
number to the called party.
Default
*7*1
Value Range
Max. 4 digits (consisting of 0–9, *, and #)
Maintenance Console Location
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main
Programming Manual References
9.27 PBX Configuration—[1-1] Configuration—Slot—Port Property - PRI Port—Supplementary Service—
COLP, CLIR, COLR, CNIP, CONP, CNIR, CONR, CF (Rerouting), CT, CCBS, E911
Feature Manual References
4.1.15 CLIP (Calling Line Identification Presentation)
15.1.20 Private Network Features
—QSIG—CLIP/COLP (Calling/Connected Line Identification Presentation)
and CNIP/CONP (Calling/Connected Name Identification Presentation)
Switch CLIP of CO Line / Extension
Specifies
the feature number used to send either the CLIP number of the CO line in use (subscriber’s number)
or the extension to the network.
Default
*7*2
Value Range
Max. 4 digits (consisting of 0–9, *, and #)
Maintenance Console Location
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main
Programming Manual References
9.27 PBX Configuration—[1-1] Configuration—Slot—Port Property - PRI Port—CO Setting—
Subscriber
Number
12.1.1 PBX Configuration—[4-1-1] Extension
—Wired Extension—Extension Settings—CLIP—
CLIP ID
12.2.1 PBX Configuration—[4-2-1] Extension
—Portable Station—Extension Settings—CLIP—
CLIP ID
Document Version 2016-03 PC Programming Manual 533
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main