Philips IntelliVue MP70 - Calibration Equipment

9 Anesthetic Gas Module Parts List
274
Calibration Equipment
The following table lists the part numbers for the calibration equipment. Calibration procedures are
explained in Chapter 4.
M1026-60122 Cable Kit (6 pieces). Includes:
Cable, Assy. 9 pin (power supply to PCB)
Cable, Assy. Flat. 40 pin (4710 head to PCB)
Cable, Assy. Flat, 26 pin (4740 head to PCB)
Cable, Assy. Flat, DB25 to 26 pin (RS232/ PCB)
Cable, Assy. Flat, 16 pin (O2 PCB to PCB)
Cable, Assy, 2 pin with LED
R
M1026-60123 Rubber Spacer Kit R
M1026-60127 Main EPROM R
M1026-60133 WT Manifold kit R
M1026-60134 WT Protector kit R
M1026-60136 Flow Split Test Kit R
2110-0495CP Fuses R
Part Number of
Kit
Description R/E
Part Number Description
M1026-60144 Electronic Flow meter
M1657B Watertrap
M1658A Sample Tubing
M1659A Calibration Tube Assembly
M1660A
1
1.This Calibration Gas Assembly cannot be ordered in Japan; use Scott Medical Products
DOT29M1060 instead.
Calibration Gas Assembly
(3% Halocarbon 22, 5% CO
2
, 40% N
2
O, 52% O
2
)
3UHYLRXVSDUWQXPEHU 1HZSDUWQXPEHU (IIHFWLYH'DWH
M1026-60101 Pump assy.,
square-shaped
M1026-60130 Pump assy.,
round-shaped
August 1997
M1026-60111 Oxygen Sensor
assy. with PC board separate
M1026-60138 Oxygen Sensor
assy. with PC board
integrated in housing
June 1998
M1026-60110 Ext.Agent-ID
M1026-60210 Ext. Agent-ID October 1998
M1026-60130 Pump Kit
M1026-60230 Pump Kit June 1999
M1026-60230 Pump Kit
M1026-60330 Pump Kit April 2000