Philips IntelliVue MP70 Service Manual

4 Troubleshooting Troubleshooting Guide
70
Wireless Network
Symptoms Possible Causes of Failure Failure Isolation and Remedy
No central monitoring
possible (see also Network
related problems)
Monitor is out of range of the access
point (in this case the yellow sync
LED on the wireless adapter on the
bottom of the device next to the
power connector is not on steady)
Move monitor back into coverage
area
Verify size of coverage with the
site survey tool
Wireless Adapter has no power
(LEDs on adapter are all off)
Check splitter cable and replace if
necessary
Check network adapter board in
monitor and replace if necessary
Check adapter itself. Replace if
necessary
(Only after first install) Firmware
revision in adapter is wrong
Update adapter frimware with
wireless support tool
Wireless adapter defective (the red
status LED on the adapter’s top
panel is on)
Replace wireless adapter
Wrong configuration in wireless
adapter or in access point
Check configuration with wireless
support tool
No connectivity (coverage
area consists of multiple
access points and in some
parts of the area there is no
connectivity)
Configuration problem
Verify the channel, domain and
security ID settings of the access
points in the coverage area
Frequent dropouts and
network disconnects
Excessive interference by other radio
equipment or by microwave ovens
Check statistics that can be read
from the wireless adapter via
RS232 or via logging application
in the PIC. Remove interfering
equipment.
System capacity exceeded in
coverage area
Check configuration guidelines
for number of monitors per access
point.
Configuration problem
Check access point configuration
with wireless support tool, in
particular the multicast filters
Overview, Printing does
not work
Some functions are not available on
a wireless network
Connect to cabled network

Philips IntelliVue MP70 Specifications

General

Brand	Philips
Model	IntelliVue MP70
Category	Medical Equipment
Language	English