EasyManuals Logo

Phoenix Contact RFC 4072S User Manual

Phoenix Contact RFC 4072S
272 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #207 background imageLoading...
Page #207 background image
Web-based management WBM
108580_en_02 PHOENIX CONTACT 207 / 272
Enabling/disabling user
authentication
To enable/disable user authentication, proceed as follows:
Click on the “Enable/Disable” button next to the “User Authentication” check box.
The “Enable/Disable User Authentication” dialog opens.
Figure 9-11 WBM: “Enable/Disable User Authentication” dialog
To enable user authentication, enable the “User Authentication” check box.
To disable user authentication, disable the “User Authentication” check box.
Click the “Save” button to apply the settings.
Recommended:
Only use the administrator password printed on the controller for logging into WBM
for the first time.
Once you have logged in successfully, change the administrator password to prevent
unauthorized administrator access.
The modified access data of the administrator is stored on the SD card.
Please note:
Enabled user authentication only provides a limited degree of protection against unautho-
rized network access.
Because of its communication interfaces, the controller should not be used in safety-crit-
ical applications without additional security appliances.
Ensure that you always operate the controller with the latest firmware version.
Follow the security advice on unauthorized network access in Section 1.6.2.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Phoenix Contact RFC 4072S and is the answer not in the manual?

Phoenix Contact RFC 4072S Specifications

General IconGeneral
BrandPhoenix Contact
ModelRFC 4072S
CategoryController
LanguageEnglish

Related product manuals