17
Polyend Tracker+ Manual
▌ PLAYING A PATTERN FROM THE PATTERN OR GENERIC PAGE.
1. Ensure a project with patterns is loaded.
2. Although not essential, it is usually good practice to display the pattern
page at this stage. If required, Press [Pattern] to display pattern page.
Note that this will play and loop the currently selected pattern, not the
entire song, unless the Song page is on display when pressing [Play].
3. Press [Play] to play the currently active pattern.
4. Press [Play] to stop playback on the current step.
• Pressing [Play] again restarts from the pattern beginning.
• Pressing [Shift] + [Play] will restart playback from the current
paused position.
• Press [Shift] + [Insert/Home] when play is stopped to reset the
playhead to the start without commencing play.
▌ PLAYING A SONG FROM SONG OR PERFORM PAGE.
1. Select song mode, Press [Song]. This will be applicable when a song
structure has previously been created for example in factory projects.
2. Press [Play] to play the currently active song. Playback in the Song or
Perform page is different to the generic pattern play from within other
page views. Each row will represent a series of patterns across the 8
tracks and play rows top to bottom.
3. Press [Play] to stop playback on the current row.
• Pressing [Play] again restarts playback starting from the beginning
of the current row.
• Pressing [Shift] + [Play] will loop playback for the current row. If
playback is in a stopped state, playback will start at the beginning of
the current row.
• Press [Shift] + [Insert / Home] when play is stopped to reset the
playhead to the start of the song without commencing play.
Overview
1
NOTES
To Next Page
Loading...
