Polyend Tracker+ - 11.2 MIDI Configuration

281
Polyend Tracker+ Manual
NOTES
MIDI
11
11.2 MIDI Conguration
A pre-requisite to working with MIDI is to ensure that the conguration
settings in the [Cong] menu are applied for the desired MIDI gear setup.
These will dictate if Tracker+ leads on functions like clock and transport or if
it acts as a secondary follower, responding to control and synchronisation
from another primary device control. Also Note and CC behaviour is set.
Velocity can be recorded from an external MIDI controller, but this must be
set in the recording options.
Menu Option Description
MIDI Clock In
Sets the Tracker+ clock between the internal
generated clock (default) or an external clock
received through the USB or MIDI In jack.
MIDI Clock Out
Sends the Tracker+ clock output to other devices.
Off, USB, MIDI Out jack or USB+MIDI jack options.
MIDI Transport In
Sets the source of transport control commands,
Internal (default), or control from an external
device received through the USB or MIDI In jack.
MIDI Transport Out
Sends Tracker+ transport control commands to
other devices. Set to Off, USB, MIDI Out jack or
USB+MIDI jack options.
MIDI Notes In
Sets the input of how notes are received from an
external device. Set to Off, USB, MIDI In jack or
USB+MIDI jack options.
MIDI Notes Input Channel
Sets the MIDI channel for external note inputs.
Select All channels or Ch 1-16.
MIDI MIDI Out
Sets the output routing of MIDI to communicate to
other devices. Set to Off, USB, MIDI Out jack or
USB+MIDI jack options.
MIDI CC In
Denes how the CC (control change) input from
external devices is handled. Set to Off, USB, MIDI
In jack, USB+MIDI In jack.
MIDI CC In channel
Sets the MIDI channel that is used to receive CC
(control change) messages. Select All channels or
Ch 1-16.
MIDI Middle C
Sets Tracker+’s middle C as C-3, C-4, C-5, C-6.
This will calibrate the note ranges to external gear
if this does not naturally match.
MIDI Clock Sync Correction
Latency compensation for incoming clock
synchronisation. Options range from -50 to +50
with each unit = 1/250 of pattern step. Leave at the
default 0.0 unless there are synchronisation errors.
Menu Option Description
Project Recording Options
This option sets the recording options for the
project. To record velocity from an external
controller one of the velocity inclusive options
should be selected.