16
Polyend Tracker+ Manual
1.4 First Steps with Factory Projects.
At rst glance, operation of Tracker appears unusual. However the
workow is quite simple once a few fundamentals are clearly understood.
The quick start button commands shown here can be applied with the
factory projects to get familiar with the essential processes to help speed
up the learning curve. Ensure the SD Card is installed.
▌ OPENING A PROJECT
1. When powering on the previous project will be restored. Projects can be
changed or new ones created. Tracker has a maximum 100 Projects
visible and accessible from the SD Card.
2. Press [File] to open the le browser.
3. Press [Open] - 2
nd
screen button from left. The list of available projects
will be displayed on the screen.
4. Turn (Jog) or Press [Up] or [Down] to navigate the list of project options.
Also press [Up] - 1
st
screen button or [Down] - 2
nd
screen button to scroll
the list selection. The highlighted option will show with a bounding box.
5. With the desired project highlighted, Press [Open] - 8
th
/ last screen
button.
6. If the currently active project has been edited a prompt ‘Do you want to
save the changes to ‘xxxx’’ will be presented. Press [Save] - 8
th
/ last
screen button to save or [Don’t Save] - 7
th
screen button from left to
proceed without saving.
7. Although not essential, it is usually good practice to display the pattern
page at this stage. If required, Press [Pattern] to display pattern page.
▌ ADJUSTING THE MASTER VOLUME.
The master volume may be set loud when initially starting up. Care should
be taken when playing songs and especially if listening with headphones. It
is advised to rstly set the master volume lower.
1. Hold [Master] + Turn (Jog). Alternatively the [Up] and [Down] buttons
can be used instead of the Jog wheel.
Press [Master] + [Delete/Backspace] to incrementally increase.
2. The Volume, as displayed on the left bar, can be adjusted between -
51.5dB to +12dB.
NOTES
Overview
1
To Next Page
Loading...
