Polyend Tracker+ - 12.8 Controlling Performances with MIDI

309
Polyend Tracker+ Manual
Performance Mode
12
NOTES
12.8 Controlling Performances with MIDI
An external MIDI controller can easily be assigned to control performance
effects in perform mode. The MIDI Incoming CC’s are predened for the 12
effect slots and the 8 track selections. The top row of the performance
effects are representative of the MIDI incoming values.
Ensure the MIDI settings for communication and the dened connection type are set correctly in the Cong
settings to ensure incoming MIDI control, clock, channel, transport etc are received correctly especially for
the incoming CC data.
Track 1
Patt: 1
---
---
-1
-1
-1
---
---
-1
-1
-1
---
---
-1
-1
-1
---
---
-1
-1
-1
---
---
-1
-1
-1
---
---
-1
-1
-1
---
---
-1
-1
-1
---
---
-1
-1
-1
---
---
-1
-1
-1
---
---
-1
-1
-1
>>>
>>>
/16
/16
/16
Fwd
Fwd
Fwd
Fwd
Fwd
Track 2
Patt: 1
Track 3
Patt: 1
Track 4
Patt: 1
Track 6
Patt: 1
Track 5
Patt: 1
Track 7
Patt: 1
Track 8
Patt: 1
Performance FX
Volume High-pass cutoff Sample end Tune Delay send Sample Playback Panning Band-pass cutoff Low-pass cutoff Sample position Reverb send
Pattern Play Mode
0m:00s P1.028
MIDI
CC51 - CC62
Effect Value
MIDI
CC41 - CC48
Track Pattern Selection
Example: Beatstep
Congured with rotaries to control the CC51-CC62 which sets the effect value. These can also
have preset CC values triggered from the pads. The CC range on the controller is 0-127 which
will be reected across the range of the effect, which may be different. For example -100 to
+100 Panning range will be controlled by a 0 to 127 CC Value.
Rotaries can also be set to select a track and a pattern using CC41-CC48. The value will
represent the pattern which can also be assigned to a pad so that this triggers a specic pattern.