Polyend Tracker+ - 11.6 MIDI CC Out

289
Polyend Tracker+ Manual
NOTES
MIDI
11
11.6 MIDI CC Out
Control change messages, also called CC, can be sent from Tracker+ on a
step by step basis. While note message will trigger the notes on other gear,
CC initiates a parameter change, for example to adjust Pan or Filter Cutoff
on another device. These would need to be matched at Tracker+ end to
align to the parameter on the external device. Six CC parameter slots A-F
exist in Tracker+ that can be allocated a CC and then used in FX1 or FX2 of
a step.
CC D
11
Velocity
127
CC A
74
CC B
5
CC C
7
Offset
0
CC F
117
CC E
64
MIDI Instrument Parameters 51. MIDI Channel 1
116
117
120 SOff
124
127
118
121 Rst
125
Prg Chg
119
123 NOff
122 Locl
126
Chan AT
52
53
56
60
63
54
57
61
64 Sust
55
59
58
62
65 Port
0 Bank
1 ModWh
4 Foot
8 Balnc
11 Exp
2 Brth
5 Glide
9
12
3
7 ChVol
6 Data
10 Pan
13
0 Bank
1 ModWh
4 Foot
8 Balnc
11 Exp
2 Brth
5 Glide
9
12
3
7 ChVol
6 Data
10 Pan
13
0 Bank
1 ModWh
4 Foot
8 Balnc
11 Exp
2 Brth
5 Glide
9
12
3
7 ChVol
6 Data
10 Pan
13
73
74
77
81
84 Porta
75
78
82
85
76
80
79
83
86
Instrument
Parameters
The instrument will assign the MIDI Channel on
which to communicate Note and CC messages.
For example MIDI Channel 2
FX1 or FX2 can be assigned by a CC command a-f
representing the 6 CC slots setup in the instrument
parameters A-F. Also a value to send is applied.
CC Numbers are assigned to a CC slot A-F in the
instrument parameter page.
a - MIDI CC A
b - MIDI CC B
c - MIDI CC C
d - MIDI CC D
e - MIDI CC E
f - MIDI CC F
This illustration shows that Control Change 74 is assigned to CC A, which in turn is assigned as FX2
with a value of 23. If, for example, Elektron Digitakt is the receiving device, this step will send a
message to control the lter cutoff.
MIDI Note Data MIDI Comms Channel MIDI CC Number MIDI CC Value
Step NOTE Step Instrument Instrument Parameters Step FX Value
Note PatternFX1
Instrument
FX2
Note PatternFX1
Instrument
FX2
C5 M02 - - a 23- -