37
Polyend Tracker+ Manual
3.2 Opening & Saving a Project - File Menu
Projects are auto saved but can also be manually saved and renamed etc.
Loading of a saved project is also possible, although on power up the
previously active project will be restored. These project management
functions are in the le menu. Note that projects copied to the SD card
must be in the main project folder. Sub folders are not viewed directly from
the ‘le’ menu.
▌ CREATING A NEW PROJECT
1. Press [File] to open the le browser menu.
2. Press [New Project] - 1
st
screen button.
3. A blank project named ‘NewProject’ is created.
▌ OPENING AN EXISTING PROJECT
1. Press [File] to open the le browser menu.
2. Press [Open] - 2
nd
screen button. The project list is displayed.
3. Turn (Jog) or Press [Up] or [Down] to navigate the list of projects to
load. Also press [Up] - 1
st
screen button or [Down] - 2
nd
screen button to
scroll the list. The highlighted option will show with a bounding box.
4. With the desired project highlighted, Press [Open] - 8
th
screen button.
5. If the currently active project has been edited a prompt ‘Do you want to
save the change to ‘xxxx’’ will be presented. Press [Save] - 8
th
/ last
screen button to save current project or Press [Don’t Save] - 7
th
screen
button from left to proceed without saving.
6. If the current pattern is new, a ‘Save As’ command is activated.
7. If required, Press [Pattern] to display pattern page.
▌ MANUALLY SAVING THE CURRENT / EXISTING PROJECT
1. Press [File] to open the le browser menu.
2. Press [Save] - 5
th
screen button from left.
3. The project will be saved and overwrite the previous version.
NOTES
Projects
3
To Next Page
Loading...
