Polyend Tracker+ - 11.5 Handling MIDI Velocity

288
Polyend Tracker+ Manual
NOTES
MIDI
11
11.5 Handling MIDI Velocity
The velocity of notes triggered by steps is set by default in the MIDI
instrument parameter page. This ranges from 0-127. An FX1 or FX2, ‘V’
Step effect can also be applied which will dene the velocity specically for
the step. External gear will receive the note message with the dened
velocity transmitted.
Recording of note data can be performed from external gear into Tracker+
in Live Recording mode using [Rec] + [Play]. To be able to record velocity,
the Cong > General > ‘Recording Options’ would need a velocity option to
be set i.e. 3 or 4 from the lost below. The options are:-
1. Only Notes: Records only quantized notes into a pattern.
2. Microtiming: Records notes with microtiming into a pattern.
3. Velocity: Records quantized notes and velocity into a pattern.
4. Microtiming + Velocity: Records notes with microtiming and velocity
into a pattern.
Note D2 recorded for instrument 8 at a recorded
velocity of 47. Note Step FX Velocity range is 0-100.
Recording options set to ‘Velocity’
Note E1 recorded for instrument 8 at a recorded
velocity of 100. Note Step FX Velocity range is 0-100.
Recording options set to ‘Velocity’
D2 08
- - - - V 47
E1 08
- - - - V100
Sends Note C5 across MIDI Channel 2 at the
default velocity in the MIDI Instrument parameters
Sends Note C5 across MIDI Channel 2 at the
velocity value of 23.
The FX value in Tracker+ is based on a range of 0-100, however most devices and DAWs use a
velocity range of 0-127. Bear this in mind when applying and recording FX velocity
C5 M02
- - - - - - - -
C5 M02
- - - -
V 23