Polyend Tracker+ - Page 215

215
Polyend Tracker+ Manual
NOTES
Audio
8
The sample recorder page can select sampling input, but the general input
is dened in the ‘Cong’ parameter settings. The Mixer passthrough audio
operates in stereo.
▌ SETTING THE SAMPLER LINE IN STEREO / MONO OPTION
1. Press [Cong] to open the conguration settings.
2. Navigate with the 1
st
and 2
nd
Screen buttons to select ‘General’.
3. In the central window pane, Press the 4
th
or 5
th
Screen buttons to
navigate to ‘Line in channel’.
4. Press [Change], 6
th
Screen button to select the options. The pop-up
window will appear.
5. In the middle page pane, Press the 4
th
or 5
th
Screen buttons to navigate
to select ‘Stereo’, ‘Mono Left’ or ‘Mono Right’.
6. Press [Apply], 6
th
Screen Button or [Cancel], 3
rd
Screen button to exit
without changing.
▌ SETTING THE MIXER LINE IN PASS THROUGH PARAMETERS
1. Press [Master] to open the conguration settings. Navigate to the Global
Mixer, Page 3 of 3, by Pressing [Master].
2. Line In by default is muted. Press [Unmute] 4
th
Screen button for the
Line In channel to toggle mute / unmute. If unmuted this will be [Mute].
3. Line In can be soloed. Press [Shift] + [Solo] 4
th
Screen button for the
Line In channel to toggle solo on or off.
4. Hold [Mute], 4
th
Screen button for Line In + Turn (Jog) to adjust level.
5. The Line in signal can also be sent to the master Delay and Reverb
effect. These channels may also be muted. Press [Mute] / [Unmute] to
toggle the Mute / Unmute State of the respective screen button.
6. To adjust the Delay and Reverb send amount, Hold [Mute] for the
respective effect screen button + Turn (Jog).
7. The Mixer bar graphs will show the audio in real time for the level,
dimmed if muted and bright if audible / unmuted. The level and send
amount settings are also shown on the bar and in the label.