Polyend Tracker+ - Page 218

218
Polyend Tracker+ Manual
NOTES
Audio
8
The radio can be heard on headphones or from the audio out while
monitoring is on in the sample recorder. Tuning is based on the region
selected and signals in the range of the current location.
▌ SETTING THE FM RADIO REGION
1. Press [Cong] to open the conguration settings.
2. Navigate with the 1
st
and 2
nd
Screen Buttons to select the ‘General’
settings.
3. In the central window pane, Press the 4
th
or 5
th
Screen buttons to
navigate to ‘Radio Region’.
4. Press [Change], 6
th
Screen button to select the options. The pop-up
window will appear.
5. In the central window pane, Press the 4
th
or 5
th
Screen buttons to
navigate to select ‘Europe’, ‘US’, ‘Australia’, or ‘Japan’. This adjusts the
radio frequencies to suit the region, but try experimenting with settings.
6. Press [Apply], 6
th
Screen Button or [Cancel], 3
rd
Screen button to exit
without changing.
▌ TUNING THE FM RADIO
1. For best results plug headphones into the out connection to act as an
antenna.
2. Press [Sample Recorder] which will allow access to the Radio.
3. Press [Source], 1
st
Screen Button, to toggle to ‘Radio’.
4. Press [Monitor], 7
th
Screen Button to toggle monitoring the audio output
on or off. Listen into the signal while tuning to nd a desirable channel.
5. Press [Radio Freq], 2
nd
Screen Button.
6. Turn (Jog] to tune the frequency signal. Alternatively, Press 3
rd
or 4
th
Screen buttons.
7. If necessary, Press [Gain], 6
th
Screen Button. Turn (Jog) to increase or
decrease the signal gain and audio level.