Polyend Tracker+ - Page 229

229
Polyend Tracker+ Manual
NOTES
Audio
8
▌ RENDER AND EXPORT A FULL SONG
1. Press [File] to select the le options page.
2. Press [Export], 6
th
Screen button to select the export specic options.
3. Press [Export Song], 1
st
Screen button to render and export.
4. The current song will be rendered and exported. Any muted tracks are
not rendered and therefore remain silent in the exported audio le.
5. A folder is created on the SD Card that represents the render. This is
located in the /Export sub folder. The le itself will be called ‘master.
wav’. Each time the song is exported a new folder is created. The folder
naming convention is:-
Project name_Song_Sequential render number
▌ RENDER AND EXPORT ALL SONG STEMS
1. Press [File] to select the le options page.
2. Press [Export], 6
th
Screen button to select the export specic options.
3. Press [Export Song Stems], 2
nd
Screen button to render and export.
4. All tracks plus the delay and reverb audio will be rendered in mono and
exported. Also a stereo master le is rendered of all tracks. Any muted
tracks are not rendered and therefore remain silent in the exported
audio le.
5. A folder is created on the SD Card that represents the render. This is
located in the /Export sub folder. The 11 les will be called ‘track 1.wav’
etc, ‘delay.wav’, ‘reverb.wav’ and ‘master.wav’. Each time the pattern is
exported a new folder is created. The folder naming convention is:-
Project name_Song_S for Stems + Sequential number