97
Polyend Tracker+ Manual
NOTES
Sequencing Steps
5
▌ DETAILED APPLICATION OF A NOTE VALUE TO A STEP EVENT
1. Press [Pattern] to select the pattern mode page.
2. Select a blank or existing step event.
3. Press [Note] to ensure the note parameter is selected in the step event.
This is a short press - do not hold [Note] otherwise this will only
temporarily select the parameter while being held.
4. Select recording mode, Press [Rec]. The steps selected will appear red
as opposed to green when in normal playback mode.
5. Set a Note by either:-
• Press [PAD] to select the note based on the note assigned to the
pad selected. Will not display note screen. Pressing [PAD] will also
iterate steps based on ‘Step Jump’ setting. Fastest Method.
• Hold [Note] + [PAD]. The pad selected will refer to the note applied.
The pads are laid out based on settings in the cong settings but
default is Chromatic, C3 - B6. Fast & Most Accurate Method.
• Hold [Note] + Press [Up] or [Down], [Left] or [Right]. Navigation and
selection is shown on the note screen. Release [Note] to select.
Accurate, But Slower Method
• Hold [Note] + Turn (Jog). Adds a note value to the step. Navigation
is displayed on the pad note screen. Accurate But Slowest Method.
• Hold [Note] alone, until pad notes are displayed and then release
[Note] to apply C0 to the step event. Applied to empty steps only.
Note can be edited later if required. Quick but Inaccurate Method.
6. The note will be added, displayed with teal coloured text. Notes are
always added along with the currently selected instrument. Notes can
be edited once created with (Jog) or [Shift] + (Jog) to change note by
full octaves.
Pads can be used to play live samples both using instruments and when
controlling external gear via MIDI from the pattern page. When in REC mode - red
state, the entire step is played including FX and respective BPM. When in the
Green, none recording mode will only play the note and instrument.
To Next Page
Loading...
