Quantum Scalar i6000 User Manual

Chapter 15: Maintaining Your Library
Maintenance Actions
Quantum Scalar i6000 User’s Guide 651
Note: Make sure that your scratch tapes are formatted and
contain no data that cannot be overwritten. Scratch tapes
must have barcode labels with valid volume serial (volser)
numbers on them. Also, you might find it useful to write
down the volser number so that you can identify your
scratch tapes.
This procedure will not damage any cartridges that are
already installed in the library.
If the scratch cartridge becomes lodged in a drive or
magazine, it must be manually removed from the library. If
not removed, the cartridge will become part of the
partition the next time the accessor assembly is enabled.
The I/E station will be locked until the inventory is complete.
10 Select a scratch cartridge of each media type listed on the following
dialog box.
Note: You can select one scratch cartridge per media type. Each
test that requires a scratch cartridge will call the media
types as needed.

Quantum Scalar i6000 Specifications

General

Form Factor	Rack-mountable
Interface	Fibre Channel, SAS
Product Type	Tape Library
Cooling	Redundant cooling fans
Dimensions	Varies by configuration
Weight	Varies by configuration
Operating Humidity	20% to 80% non-condensing
Scalability	Scalable
Drive Types	LTO
Redundancy	Redundant power supplies
Management	Web-based management
Tape Technology	LTO
Supported Media	LTO Ultrium 9, LTO Ultrium 8, LTO Ultrium 7, LTO Ultrium 6
Power Supply	Redundant power supplies
Non-operating Humidity	5% to 95% non-condensing