Quantum Scalar i6000 - Specifying the Date and Time

Chapter 3: Configuring Your Library
Specifying the Date and Time
Quantum Scalar i6000 User’s Guide 185
included in the diagnostics, see Using EKM Path Diagnostics on
page 311.
Default configurations are as follows:
• Q-EKM — Not available.
• SKM — Enabled by default. You can disable it for SKM but it is
not recommended unless directed by a service technician. The
background diagnostic should always be enabled so the library
can monitor SKM server status and report issues as soon as they
arise.
• KMIP key managers - Enabled; cannot be disabled.
9 When finished, click OK.
Specifying the Date and Time
You can use the Date and Time command to set or reset the system
time. If you want to synchronize the library over a network, you can use
the Network Time Protocol (NTP) setting. The default date and time is
Greenwich Mean Time (GMT).
To set the date and time or to use NTP:
1 Log on as an administrator.
2 Make sure that you are viewing the physical library. From the View
menu, click the name of the physical library.
3 Click Setup > Date and Time. The Date and Time dialog box
appears.