Chapter 14: Using the Command Line Interface
Command Line Interface (CLI) Commands
Quantum Scalar i6000 User’s Guide 503
Issuing a Command
from the Initial Prompt
CLI Command List The following commands are available. The commands and their usage
are described below.
• show media on page 504
• move media on page 505
• show firmware revisions on page 507
• show library status on page 508
• show network information on page 509
• set network ip on page 509
• show library configuration on page 510
• show partitions on page 511
• set partition online/offline on page 512
• reboot library on page 513
Welcome to the XXX Library Command Line Interface.
Type 'help' at the prompt for context-sensitive help.
/> move media p1 s10 d1
/set> drive
/set/drive>
To Next Page