Quantum Scalar i6000 - Page 527

Chapter 14: Using the Command Line Interface
Command Line Interface (CLI) Commands
Quantum Scalar i6000 User’s Guide 509
show network information
set network ip
show network info
description: Shows the current library network configuration.
This command should show the library IPv4 and IPv6 configuration, current
addresses, etc.
examples:
show network information
/>show net info
- Hostname: dvt20-ms.hw.quantum.com
- Domain Name: N/A
- IP versions(s) enabled: IPv4 enabled, IPv6 disabled
- DHCPv4: disabled
- IPv4 addr/mask/gtwy: 10.20.171.25 / 255.255.248.0 / 10.20.168.1/>
set network ip
description: Allows the user to set the basic IPv4 static address information.
examples:
set network ip
/>set net ip 10.0.0.3 255.255.255.0 10.0.0.1
/>