Chapter 3: Configuring Your Library
Running the Setup Wizard
124 Quantum Scalar i6000 User’s Guide
• Setting Up Media Security Notifications on page 196
• Configuring Devices on page 198
• Configuring Drive Cleaning on page 227
• Registering SNMP Traps on page 233
• Configuring Library Security on page 235
• Using LDAP on page 241
• Configuring Screen Saver Preferences on page 248
• Working With Data Path Conditioning on page 250
• About the Configuration Record on page 252
• Setting Aisle Lights on page 253
• Configuring a Webcam For Your Library on page 254
• Working with Towers on page 255
For a brief overview of the LMC, see Library Management Console (LMC)
on page 442.
If you are configuring your library for the first time, see the
Scalar i6000
Installation Guide
for information about performing an initial library
configuration.
Note: Only one administrator can be logged on and performing
library configuration at any one time. If another administrator
attempts to log on, a message appears, warning that only one
administrator at a time is permitted on the library. If a service
user logs on while an administrator or regular users are logged
on already, the library automatically logs off those users.
Running the Setup Wizard
Use the Setup Wizard command to initially configure important
settings on a library as part of the normal installation procedure. Before
you can manage your library from a remote LMC client, you must
initially configure the library from its touch screen by either running the
Setup Wizard command or using individual configuration commands
To Next Page
Loading...
